Battery Chargers

Battery Charger

Float charging, 67 KHz switching, Constant output voltage Current limiting, Fail (Relay) output, High Current and short circuit protection, Reverse connection protection, High temperature protection, Wide range operation voltage, Suitable for Lead Acid battery

Trans-MiniAUTOAutomatic Genset Controller

Log last 50 events & alarm information with measured values
Statistics records
Power factor measurement for 1 phases
Selectable Resistive sender types; Pt-100, VDO, US, GM, Ford, Datcon, etc..
Engine control
Compatible to Diesel or Gas generators
SPN, FMI and OC values reading from engines via J1939

Trans-MidiAUTOAutomatic GenSet Controller

Log last 50 events & alarm information wiht measured values
Statistics records
Generator phase sequence control
Power factor measurement for 3 phases
Selectable Resistive sender types; Pt-100 VDO, US, GM, Ford, Datcon, etc...
CanBus J1939 ECU communication
SPN, FMI and OC values reading from engines via J1939
Active, Reactive, Apparent power measurement

Trans-MiniATSAutomatic Transfer Switching Controllers

Parameter configuration via RS-232 serial communication
Log last 50 events & alarm information with measured values
Statistics records
Remote Start/Stop output
Mains voltage failure detection
Emergency backup and Test mode

The EL7-ECS servo represents Leadshine's latest generation EL7 AC servo drive, with a Speed Loop Bandwidth up to 3.5 kHz.

Operating within a power range of 400-7500W, its key features include:safety compliance, with control power circuit and main power circuit separated. New LTune Intelligent Tuning function. The minimum communication data update cycle has been reduced from 250 to 62.5 µs, enabling faster response times and more precise trajectory control. It meets STO and UL certification requirements. Main applications encompass photovoltaic systems, lithium battery manufacturing, semiconductor production,robotics,electronics,laser technology and so on.

ESM-3712-HCNDigital ON / OFF Temperature Controller(ALARM+SET)

Installing parameters using Prokey
2 Output for compressor and alarm controls
Process Set value and Alarm Set value low limit and
set value high limit boundaries
4 Digits Display
NTC Inputor PTC Input (Must be determined in order)
ON/OFF temperature control
Selectable heating or cooling function
Selection of operation with hysteresis
Adjustable temperature offset
Alarm parameters
Adjustable internal buzzer according to Sensor
prob defect and Alarm status
Remote access, data collecting and controlling
with Modbus RTU (Optional)