ESM-1510-N

Auto Start Moto-Pump Protection Control

Parameter configuration via RS-232 serial communication
Log last 50 events & alarm information with measured values
Statistics records
Selectable Resistive sender types; Pt-100, VDO, US, GM, Ford, Datcon, etc..
Compatible to Diesel or Gas engines
Remote Start

Battery Charger

Float charging, 67 KHz switching, Constant output voltage Current limiting, Fail (Relay) output, High Current and short circuit protection, Reverse connection protection, High temperature protection, Wide range operation voltage, Suitable for Lead Acid battery

Trans-MidiAUTOAutomatic GenSet Controller

Log last 50 events & alarm information wiht measured values
Statistics records
Generator phase sequence control
Power factor measurement for 3 phases
Selectable Resistive sender types; Pt-100 VDO, US, GM, Ford, Datcon, etc...
CanBus J1939 ECU communication
SPN, FMI and OC values reading from engines via J1939
Active, Reactive, Apparent power measurement

Trans-CRANK Manuel Start Unit with Key Switch

Designed for generator,Pump & Fire Pump Applications Engine start/stop,Automatic shutdown on fault condition,Provides alarm and status information,Alarm and shutdown inputs,Provides charge alternator excitation currrent,Lamp test function

ECO LITEOn-Off Temperature Control Unit

TC (J,K,R,S,T Input Types) and
RTD inputs selectable by parameter
Low Power Consumption, Energy
saving and Environmentally Friendly with 2VA
Saving and Recovery of user parameters
Return to Factory Settings
3 Digits Process (PV) and 4 Digits Set (SV) display
ON-OFF control form
Selectable heating and cooling function
Selectable temperature offset value
Operation type selection with hysteresis
Minimum pulling time adjustment
for control outputs

Trans-Midi AMFAutomatic GenSet Controller with Transfer Switching

Log last 50 events & alarm information wiht measured values
Statistics records
Mains & Generator phase sequence control
Selectable Resistive sender types; Pt-100 VDO, US, GM, Ford, Datcon, etc...
CanBus J1939 ECU communication
SPN, FMI and OC values reading from engines via J1939
Remote Start/Stop Speed and Idle mode Control via J1939
Local Remote Control and Visualisation function